SOULCRAFT

The RunPod install

Three steps to your first image.

Buy, paste one line into your pod, open ComfyUI.

  1. Step 1: Buy

    Your receipt holds your key. It starts with SOULCRAFT_.

    Go to the shop

  2. Step 2: Paste one line

    Start a RunPod GPU pod with a network volume, open its terminal, paste the line below.

  3. Step 3: Open ComfyUI

    When the line says done, Connect on port 8188. Your workflows are in the list.

The one line

curl -fsSL https://soulcraft.computer/boot | SOULCRAFT_KEY=SOULCRAFT_XXXXX-XXXXX-XXXXX-XXXXX bash
Replace the Xs with your key before you press Enter.

What happens

What happens when you paste the lineYour pod: runs the line, then /boot: fetches the script, then Key check: what your key covers, then Packages install: base first, then yours, then ComfyUI opens: on port 8188Your podruns the line/bootfetches the scriptKey checkwhat your key coversPackages installbase first, then yoursComfyUI openson port 8188What happens when you paste the lineYour pod: runs the line, then /boot: fetches the script, then Key check: what your key covers, then Packages install: base first, then yours, then ComfyUI opens: on port 8188Your podruns the line/bootfetches the scriptKey checkwhat your key coversPackages installbase first, then yoursComfyUI openson port 8188

Not on RunPod?

The same line works on Crusoe, Verda or your own GPU: any machine that meets the base's requirements.

Stuck? Write to support@soulcraft.computer, or read Buy to first image.